How to Limit WiFi users bandwidth connected to modem or router?

If you have Internet or wifi network in your home or office then this trick is very useful for you because by using this facility or trick on you can control internet bandwidth limit from your router or modem. But It is totally depends on the type of router you are using in your home or office. Most of the modems and routers have bandwidth control function but, they will allow controlling the speed of all connected devices at once.

Here is complete and best procedure to limit internet downloading and uploading speed to WiFi users bandwidth connected to Digisol, D-Link, iBall, Tenda and TP-link modem or routers.

 First Login to your router or modem by using routers gateway address; usually most of modems have "192.168.0.1" or "192.168.1.1"

Login to your router >> Check for Bandwidth Control Option in your router options >> Enable and set bandwidth.

Assigning different bandwidth to different devices is not possible directly. So, there is a hack to do so.

First note all IP address and Mac address from DHCP server for current connected devices. Set DHCP server to off. (Now you need to assign IP's manually to each and every device.)

Login to your Router Page

Go to DHCP tab and make sure that you have enabled DHCP SERVER

Now under DHCP tab you will see an option as DHCP Client List

You will see list of devices connected to your wifi with ip addresses

Copy the preferred IP address

Now go to BANDWIDTH CONTROL > RULE LIST

Now click on ADD NEW, now paste the IP address (IP range) which you have copied in STEP 4

Now Set the Egress Bandwidth and Ingress Bandwidth

For Control Uploading Speed go to>> Egress bandwidth

For Control Downloading Speed go to>> Ingress bandwidth

IP Range -Single IP address or IP address Range. When you configure the single IP address, the computer with this IP address will get independent given bandwidth. When you configure the IP address range, all computers in the range will share the given bandwidth.

Port Range-The port arrange of TCP protocol or UDP protocol.

Protocol-You can choose the TCP protocol or UDP protocol or both of them.

And now save the settings and check the box to enable or disable these setting. If you have another company modem then you can find Bandwidth control function as below...

Digisol Router: Advanced > QoS setup

D-Link Router: Advanced > Traffic Control

iBall Router: Bandwidth Control

Tenda Router: QoS>>Bandwidth Control